Increasing data accuracy for FPGA software
on Monday, July 29th, 2019 1:54 | by Anders Eriksson
Category: Uncategorized | No Comments
Heat shock
on Monday, July 22nd, 2019 12:39 | by Andreas Ehweiner

Category: Uncategorized | No Comments
Flight test of FoxP mutant
on Monday, July 22nd, 2019 12:35 | by Andreas Ehweiner

Category: Uncategorized | No Comments
t- mase experiments results of first five experiments
on Monday, July 22nd, 2019 11:10 | by kader semiz
Category: Uncategorized | No Comments
Optimizing optomotor response, part 2
on Friday, May 10th, 2019 4:20 | by Anders Eriksson
The optomotor stimulus consists of a striped arena with panoramic vertical stripes rotating horizontally around the vertical, or yaw axis. Depending on the spatial wavelenght (or spatial frequency, SF) the fly’s optomotor response (OR) is changing supposedly to reach a maximum between 20-40°
(with a pattern motion of 0° ) . As the panoramic stripes are rotating a tethered fly will actively steer in the direction of the motion. After its maximum the OR gradually decreases with an increasing spatial frequency to finally reach 0 around 9.6-6.3°. A tendency to negative/reversed OR has been observed as the SF reaches 6.3°.

This experiment has been shown before in 1976 by E. Buchner, Elementary movement detectors in an insect visual system. Bioi Cybern 24:85- 101, Figure 8 page 93. Attaching Figure 8 as a reference.

Category: Uncategorized | No Comments
Optimizing optomotor response
on Tuesday, May 7th, 2019 4:56 | by Anders Eriksson
Category: Uncategorized | No Comments
Habit formation, Registered Report
on Monday, April 1st, 2019 2:16 | by Anders Eriksson
Started to write the manuscript for the registered report about Habit formation. Aiming for European Journal of Neuroscience.


Category: Uncategorized | No Comments
Software stops measuring at the correct sample rate
on Monday, March 25th, 2019 2:59 | by Anders Eriksson

Category: Uncategorized | No Comments
Noise measurements
on Wednesday, March 20th, 2019 9:06 | by Anders Eriksson
Three different kind of noises has been measured: Without input from the torquemeter, without input from the PCB and one also with everything connected but the power supply turned off.

Category: Uncategorized | No Comments
Finding errors in the new software
on Monday, February 18th, 2019 3:00 | by Anders Eriksson

Category: Uncategorized | No Comments


